The power strips provided with the hardware use a detachable inlet cord set that mates to an IEC 320 - C20 receptacle on the power strip. Unisys provides three types of power cords; select the appropriate power cord based on your location and provide the applicable mating receptacle. In addition to power cords available from Unisys, you can choose to use cord sets that meet local standards and codes with localized plugs that are not supplied by Unisys.
Each power cord must be protected by circuit breakers with the applicable rating.
Power cords are a maximum of 3 m (10 ft) in length. Receptacles should be located within 2 m (6.6 ft) of the cabinet to allow adequate length for routing power cords within the cabinet while avoiding undue stress on the cords.
The AC entrance requirements, available power cords, and mating receptacle requirements are listed in AC Entrance Requirements and Available Power Cords and Mating Receptacle Requirements.
Table 2. AC Entrance Requirements
Locality | Frequency | Voltage | Number of AC Entries Required per Cabinet | Input Source AC Circuit Rating | Power Strip Output Load Rating |
|---|---|---|---|---|---|
US, Canada | 50/60 Hz | 200 – 240 V 1 phase | 4 or 6 | 20 A | 16 A |
International | 50/60 Hz | 200 – 240 V 1 phase | 4 or 6 | 16 A | 16 A |
Table 3. Available Power Cords and Mating Receptacle Requirements
Locality | Power Cord Type | Connector Description | Mating Receptacle Face View (Customer-Supplied) |
|---|---|---|---|
US, Canada | LC1-M | NEMA L6-20R (20 A , 208 V, 2 power, 3 wires) |  |
International | LC1-Q | IEC 60309 316-R6 (16 A, 200 to 250 V, 2 power, 3 wires) Note: Alternate receptacle description is IEC 60309 16 A. |  |
LC1-UVH | No Plug (16 A, 200 to 240 V, Live: Brown, Neutral: Blue, Ground: Green/Yellow) |  |