To initiate LINC/MON, perform one of the following:
From CANDE, enter the command:
RUN $[(usercode)]NGEN28/MON [ON pack]
From the ODT, enter:
USER=usercode/password RUN [(runuser)]NGEN28/MON [ON pack]
Alternatively, you can set up a COMS window for LINC/MON, thereby allowing selected users to initiate LINC/MON by signing on to the window as follows:
?ON windowThe parameters used in these commands are described in the following table.
| Parameter | Description |
|---|---|
| pack | Pack on which the LINC/MON program resides. Omit ON pack if it is on a family pack for that usercode. |
| usercode | Usercode under which the LINC/MON program resides. Omit if it is visible to the current usercode. |
| runuser | Usercode under which you wish the LINC/MON program to run. |
| window | COMS remote file window for LINC/MON, if applicable. |